Mechatronics Processing Station Training System
A work piece carrier is located on the conveyor belt. It is loaded with a fully assembled two-component work piece (top and bottom pieces). The carrier and its load are positioned beneath the process module. The work piece is clamped for processing. A bolt from the gravity-feed magazine is pressed into the hole in the work piece. The clamp opens and the carrier and load are conveyed to the end of the belt to be passed on to the next sub-system.

This Training System is available in the following configurations:
  • Training System controlled by a PLC

  • Training System controlled by a UniTrain-I System
Training Concepts:
  • Assembly, set-up and testing of pneumatic cylinders and valves
  • Identification of workpieces
  • Monitoring of a process sequence
  • Definition of a process sequence for simple processing
  • Programming of production sequence in manual and automatic modes
Product: Mechatronics Processing Station Training System
Product Code: IMS 5

Information cart is empty